Y me dio tiempo a otra cosilla, de la caja, el piñón para el odometro mecanico, lleva un retén que suele fugar Sacar esta pieza se las trae Para extraer el retén viejo Esto va aquí…
come to the dashboard wood, as I have two of these, doing in pairs, on one of them I found a crack in the weakest point, it is a delicate part, not only narrow but also thin due to a cavity below, it is prone to cracks, both of mine were broken, this one was catastrophic , so did a compound to restore the structural rigidity by adding four strong pieces stitching the wood
siguiendo con salpicadero,…presentando cosas Mas o menos asi…me lo ha chivado xevi principio y marcas Recuperando grab-bar
who needs metaverse ? Cuando puedes coser… the rebel paper template...and the solid keepers ready fantastic some tips, before starting use only one side marked and place the other side with plenty of excess, you will cut it afterwards sew 4mm inside the border or give 4 mm excess, when you turn it inside out you will have that small corner to introduce it in the rubber channel of the lateral console before starting sewing just sew 1cm long in both extremes to somehow fix the 2 pieces so that they do not move in excess enjoy
Otra tribulación, esta vez resulta a medias, para la caja renovada ando sin pivote es esta cosita… i can see no other way than pressure, but would it be a thread there
finally it was necessary to build one diameters 12 and 23, a bit tricky, some 0,... needed to be removed to instert in their respective places
a difficult time it came with the need for fixing the horizontal wood piece to the vertical ones i made a trial on the body mounted on duct tape, it seemed fine, but setting some screws freeze everything in place forever, i used the trim part as a support to join both wood bits on top, them i checked how the shapes fit together, made some changes in positions and started with the joint procedure i felt that in order to introduce the screws the process is a bit laborious as drilling is involved i found better to use nails as references, but i predrill the position, the nails to be removed afterwards i used torx headed SS screws, 3x30 for the wood to wood, drilling with a 2mm drill then 3x16 for the top alu trim, a bit longer than the originals, but originals seemed ridiculous like 3x8 went well, satisfied with outcome.
paneles de consolas laterales: as to the wood that was finished months ago it still needed the rubber and the foam, so... so, once all this was ready it only took 2 hours to complete the upholstery process,...i am getting old... most difficult part is to get the edges inside the rubber channel... start in one corner back side then turn other side and pull while puting staples to fix keep the tension and work the other end tools relevant: ready for the alu trim lines
y comprobando el conducto de la calefaccion: los fieltros se usan para sellar las bocas, y en el interior para reducir el ruido producido por el aire y amortiguar el ruido del exterior
Para terminar con las consolas el todo o nada de las molduras de aluminio, si te equivocas hay que tirar las fundas y hacerlas nuevas, es un momento crítico